Palsonic 6138 Manuel d'utilisateur télécharger pdf (Page 3)

OPERATING INSTRUCTION:

POWER ON/OFF SWITCH

Press the Power Switch, the appliance will be in "STANDBY" mode. A red light shows on

the control panel. Press "PR-/+" buttons to turn on the set. The red light goes out, and

a green light, shows on the control panel.

If there is no TV signal on the screen for five minutes, the TV set switches to STANDBY

automatically. The red light is on.

Pressing the Power Switch again disconnects the set’s power. The light goes out.

STANDBY:

In STANDBY the set takes power to run the remote control circuitry, but the main power

is disconnected. The Red light is on.

1. Pressing any of these buttons will bring the set out of STANDBY and turn it on.

(1) Position Selector PR(-/+) on the remote control or the front panel will recall the

previous setting.

(2) RECALL will recall the previous setting before the set was turned off.

(3) Digital Numbers 0 ~ 9 will switch the set to whichever number is pressed.

2. To put the set into STANDBY press the ( ) button on the Remote Control

unit. This only turns it OFF, it will not turn it ON.

CHANNEL SELECTION:

This set is pretuned to Australian channels 2, 7, 9, 10 & 28 on those numbers. If you

wish to change the settings or add more channels, the method is quite straightforward.

SOUND II INDICATOR

STEREO INDICATOR

SOUND I INDICATOR

POWER SWITCH

POWER INDICATOR

STAND BY INDICATOR

INFRARED SENSOR

PUSH OPEN

EXTERNAL SPEAKERS

EX./IN SPEAKER SWITCH

VIDEO OUTPUT

AUDIO OUTPUT

ANTENNA INPUT

VIDEO INPUT

AUDIO INPUT

1 2 3 4 5 6 7 8 ... 17 18

Pas de commentaire

Palsonic 6138 Manuel d'utilisateur Page 3